Toshiba AW-G9930S/G1130S Service Manual page 21

Diagnosis
8
(1) Whether foreign matter is caught on the pulsator.
Abnormal noise
(2) Whether the machine is placed on a firm and flat floor.
occurs
(3) Whether there is an excessively uneven load in the spin
basket.
(4) The noise
the water intake valve is operated and the noise
is generated by the liquid for balance in the spin basket.
These are not troubles.
(5) You may hear intermittent motor sound (
spinning process occurs, this is a sound which occurs in
order to control rotation, and not a malfunction.
9
(1) Whether power failure occurs.
The washing
(2) Whether the house circuit breaker is tripped or a fuse is
machine does not blown.
operate.
(3) Whether the power cord is connected to the socket
properly.
(4) Whether the power switch turn on, the START/HOLD
button is pressed.
(5) Whether the tap is opened.
(1 Warning alarm [E5] is operated.)
(6) Whether the proper amount of water is filled.
(7) Whether the drain hose is laid down. If the machine is
operated without laying the drain hose down, the operation
stops to prevent water flowing around the floor.
(1 Warning alarm [E1] is operated.)
!
Whether the softener solidifies in the softener case.
Softener is not
effective.
"
Because of the water pressure, the quality of cloth and the
The remaining time draining condition, the total time may be long.
does not suit to the
If the automatic unbalance correction is operated, the
total time.
remaining time is increased.
#
If you put the wet clothes, it may be set the water level higher.
Water level
controlled by the
washing amount
sensor does not
reach to the
expected level.
$
Turn off the power switch once and turn on again. Then try
The operation is
the operation again.
not performed to
If the machine would not operate, unplug the power cord
be expected.
once and plug it in to start operation again.
%
When water is supplied some amount, the pulsator rotates.
The pulsator rotates Then washing and rinsing start.
during water
supplying in the
wash or rinse cycle.
&
By spinning control, for some time (approx. 2 - 3 min.) after
The spinning spinning started, the rotation speed is low.
speed varies.
For spinning the rotation speed varies and you may hear
motor sound (
controlled.
Check Point
boon in supplying water is generated when
" "
coon sound). It cause the rotation speed is
" "
– 20 –
After repairing, press the
START/HOLD button
again.
za zaa
" "
coon sound) in
" "
After repairing, press the
START/HOLD button
again.
Remove the softener case
and wash it.
This is not trouble.
Adjust the washing
amount sensor.
(Refer to the Owner's
Manual)
Refer to the Owner's
Manual
This is not trouble.
This is not trouble.
Remedy