No Problem Diagnosis - Toshiba AW-G9930S/G1130S Service Manual

Please check the following.
Diagnosis
1
Refer to pages 12 to 13.
The warning buzzer
will sound and the
digital display will
indicate the error.
(Warning alarm
condition)
2
(1) Whether it is warning alarm condition as 1
Stops while
(2) Whether it is set to no spin process with pressing on SPIN
operating process.
3
(1) Whether the WASH, RINSE and SPIN button is pushed
During the process,
WASH, RINSE and
(2) Whether it is changed process while operating rinse and/
SPIN button does
not operate.
4
Whether it is set to preset.
START/HOLD
button does not
operate.
5
(1) Whether it is set to no spin process with pressing on SPIN
Poor drain
No drain
(2) Whether the drain hose is at
Hard to drain
(3) Whether too long extension hose
(4) Whether a slender extension

7-3. NO PROBLEM DIAGNOSIS

Check Point
button. (When no spin process is selected, the pulsator
stops at the end of last rinse operation without draining.)
after beginning the operation.
or spin process.
button
proper height.
(Whether it is warning alarm
condition.)
is used.
(Whether it is warning alarm
condition.)
hose ϕ 25 which is not Toshiba's
option is used.
(Whether it is warning alarm
condition.)
– 18 –
Remedy
Refer to pages 12 to 13.
Same as 1
Press the COURSE button
only, then will be operated
automatically from washing
to spinning.
Press the START/HOLD
button, then set again.
This is not trouble.
Turn off the power switch
and reset.
This is not trouble.
Turn off the power switch
and cancel preset.
Same as 2 - (2).
Set the hose height less
than 15 cm.
Use less than 3.0 m hose
on flat surface.
Replace it to Toshiba's
optional extension hose.
(Part No. 42T40017)