ProForm PFEX74207.1 User Manual page 9

9. Push the seat handle down. Pull the Seat Carriage
(41) towards the back of the exercise cycle until it
stops. Then, pull up on the seat handle to lock the
Seat Carriage in place.
While another person holds the Seat Bracket (11)
near the Seat Carriage (41), connect the Right
Controller Wire (82), which has a tag attached, to
the wire on the Rear Wire Harness (51) that has a
tag attached. Then, connect the Left Controller Wire
(61) to the other wire on the Rear Wire Harness.
Make sure that the connectors on the Controller
Wires (61, 82) are positioned side by side under
the plastic cover on the Seat Bracket.
Be careful to avoid pinching and damaging the
wires. Attach the Seat Bracket (11) to the Seat
Carriage (41) with four M8 x 19mm Button Screws
(77) and four M8 Split Washers (55).
10. Identify the Left Pedal (22), which is marked with an
"L." Using an adjustable wrench, firmly tighten the
Left Pedal counterclockwise into the Left Crank
Arm (24). Tighten the Right Pedal (not shown)
clockwise into the Right Crank Arm (not shown).
IMPORTANT: Tighten both Pedals as firmly as
possible. After using the exercise cycle for one
week, retighten the Pedals.
Adjust the strap on the Left Pedal (22) to the
desired position, and press the end of the strap
onto the tab on the Left Pedal. Adjust the Right
Pedal Strap (not shown) in the same way.
11. Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
9
Avoid pinching and
damaging the wires
11
77
10
Strap
22
Tab
24
9
77
55
Plastic
Cover
61
82
Seat
55
Handle
41
51