Lightronics FXLD354WAI Owner's Manual

Version 0.1
FEATURES AND SPECIFICATIONS
LEDs: 54 Three Watt LEDs
36 daylight white (5800 - 6000 K)
18 warm white (3200 - 43200 K)
Color Mixed Color Temp. Range: 3200 - 4200 K
Beam angle: 25 º
Control system: DMX-512 + Stand Alone
DMX channels: 8
DMX connectors: 3 pin XLR
Voltage: 100 - 250 VAC 50/60Hz
Max power consumption: 200 Watts
Size: 17 3/8"W x 8 1/4"H x 12 1/4"D
Body material: Cast Aluminum
Body color: Black
Weight: 17.6 lbs
DESCRIPTION
The FXLD354WAI is a WHITE / WARM WHITE
LED lighting fixture. It is suitable for stage, disco,
night club, and other artistic applications.
several stand alone control modes, a master/slave
mode, and can operate via a DMX-512 external signal.
A double yoke enables the fixture to be operated in
several positions.
INSTALLATION
LOCATION
The FXLD354WAI is rated IP20 and is intended for
INDOOR USE ONLY.
Locate the unit in a well ventilated area away from
moisture and heat. Keep the vent holes clear. Holes
are provided on the yokes to install a lighting bar pipe
clamp. Use a safety cable when hanging the fixture.
POWER CONNECTIONS
The FXLD354WAI has a line cord for connection to a
120 VAC, 15 Amp, 60Hz, grounded service.
RISK OF ELECTRIC SHOCK
The safety ground pin on the power cord must be used.
www.lightronics.com
Lightronics Inc.
FXLD354WAI LED FIXTURE
OWNERS MANUAL
It has
CAUTION
509 Central Drive Virginia Beach, Va 234354
DMX CONNECTIONS
A system using DMX control should be connected as a
chain of devices. In other words the control signal
cable should proceed from the controller to the first
receiving device and then to others in a continuous
"daisy chain" fashion.
The fixture has a DMX IN and a DMX OUT connector
to be used to connect the chain. The control cable
should NOT be split into a multiple run star
arrangement with a cable running from the controller
directly to each receiving device pack.
DMX CONNECTOR PIN ASSIGNMENTS
There are two different connectors which can be used
for DMX control. They are both XLR type connectors.
Some units use 3 pin connectors. Others use 5 pin
connectors. The FXLD354WAI receives a DMX signal
on the 3 pin MALE connector on one side of the unit.
The 3 pin FEMALE connector is used to connect the
next DMX device on the control chain. If your console
uses a 5 pin connector you can make up an adapter
cable to accommodate this. The table below shows the
pin assignments for BOTH the 3 pin and 5 pin
connectors.
IN # SIGNAL NAME
1 DMX COMMON
2 DMX DATA -
3 DMX DATA +
4 NOT USED
5 NOT USED
Page 1 of 6
07/07/2011
757 486 3588