Operating The Homelink; Erasing The Entire Homelink Memory - Lexus RX300 2001 Owner's Manual

INTERIOR EQUIPMENT
Reprogramming a button
R
Individual HomeLink
buttons cannot be erased, however,
to reprogram a single button, follow the procedure
"Programming the HomeLink
(b) Operating the HomeLink
To operate the HomeLink
R
HomeLink
button to activate the programmed device. The
R
HomeLink
indicator light should come on.
R
HomeLink
continues to send the signal for up to 20
seconds as long as the button is pressed.
(c) Erasing the entire HomeLink
(all three programs)
To erase all previously programmed codes at one time, press
and hold down the 2 outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase the programs stored
R
in the HomeLink
memory.
CAUTION
When programming the HomeLink
Transceiver, you may be operating a garage door or
other device. Make sure people and objects are out
of the way of the garage door or other device to
prevent potential harm or damage.
62
R
".
R
R
, press the appropriate
The
R
memory
R
Universal
2001 MY RX300_U (OM48431U)
R
Do not use this HomeLink
Universal Transceiver
with any garage door opener that lacks the safety
stop and reverse feature as required by federal safety
standards. (This includes any garage door opener
model manufactured before April 1, 1982.) A garage
door opener, which cannot detect an object,
signaling the door to stop and reverse, does not meet
current federal safety standards. Using a garage
door opener without these features increases risk of
serious injury or death.
FCC ID: CB2SAHL3
CANADA: 279 102 1849A
This device complies with FCC Rules Part 15.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference that
may be received, including interference that may
cause undesired operation.
transmitter has been tested and complies with
FCC and DOC/MDC rules.
modifications not expressly approved by the party
responsible for compliance could void the user's
authority to operate the device.
WARNING: This
Changes or