Avery Dennison MONARCH 9825 Addendum page 6

D e f i n i n g t h e R F I D S e t u p P a c k e t f o r U H F ( 9 8 5 5 o n l y )
Use the RFID setup packet (X) to set the protocol, write attempts, read
power, write power, and signal adjust.
Note: Refer to the RFID Setup Guide and Supply Chart for the read and
write power settings and signal adjustment based on your RFID
supplies.
Syntax
{I,X,protocol,write_attem,read_power,
write_power,signal_adjust¦}
X1. X
X2. protocol
X3. write_attem
X4. read_power
X5. write_power
X6. signal_adjust The strength of the RF Field emitted by the printer's
Example {I,X,0,3,10,10,6¦}
Uses the default protocol (Class 1 Gen 2), sets the number of write attempts
to 3, sets the read and write power to 10 and the signal adjustment to 6.
The test label has been updated to show the settings for the RFID Setup
Packet.
6
RFID Setup Packet
Select the UHF protocol. The default is 0. Options:
0 C1Gen2 (Class 1 Gen 2)
1 C1Gen1 96 (Class 1 Gen 1 96-bit)
2 C1Gen1 EPC64/96 (Class 1 Gen 1 EPC64/96)
3 EM4122
The number of times the interrogator tries to program the
RFID tag in the RF Field. The range is 1 – 5. The
default is 3.
The amount of power to read an RFID tag. The range is
1 – 25. For the Japanese frequency, the range is 1 – 10.
The default is 18.
The amount of power to write (program) an RFID tag.
The range is 1 – 25. For the Japanese frequency, the
range is 1 – 10. The default is 18.
antenna. The higher the value, the greater the power of
the RF Field. The signal adjustment varies depending on
the selected protocol. The range is 2 – 10. The default
is 2.
RFID Setup Packet