Advertisement
Cooling with dehumidification
1
Air flow
Install the flexible hose onto the air conditioner. To
improve the air conditioner performance make sure that:
- the internal tips of the flexible hose are turned as
shown in the picture;
- the hose is stretched as little as possible;
- the hose is not bent, folded or throttled.
4
Plug the unit in.
Open the air flow direction guide vane.
7
The fan speed can be selected by
pressing the
button.
GB - 4
Air flow
5
The unit is now ready for cooling.
Ensure that the warm air discharged from
the end of the hose is not obstructed.
8
MIN.
MAX.
When the desired room temperature is
reached turn the thermostat control knob
counterclockwise until the compressor
switches off.
In this way the desired room temperature
is automatically maintained.
To switch the unit off, press the
2
Move the air conditioner close to
the window and place the hose
end outside stretching the hose as
little as possible (max. extension
1100 mm).
button.
3
Make sure the flexible hose is not
kinked or curved too tightly and that it
is placed on a supporting surface
(windowsill, floor...).
6
Set the thermostat to maximum
cooling by turning the control knob
clockwise.
Press the
button.
9
If the indicator light on the control panel
light up, this shows that the condensate
water collection tank is full. If this is the
case the unit automatically switches off.
To empty the tank, switch the unit off
by pressing the button
and remove
the plug from the power supply
socket.
Take out the full water tank on the rear
side of the air conditioner and empty it.
Then replace it correctly in its position.
Plug in the unit and wait at least 5
minutes before again restarting the air
conditioner (button
).
Advertisement
