Table of Contents
Advertisement
4.- Screw the entire feedthru assembly into
the RJ45-ECS housing which is already
mounted in the CPE. There should be a
rubber gasket between the two assemblies.
RJ45-ECS housing
Tighten the feedthru assembly to create a
seal.
5.- The final step is to tighten the
compression nut until the gaskets are tight
around the Cat5 cable. Always push the
cable toward the connector while tightening
to ensure good strain relief of cable to
connector.
Step 2
From the PoE injector connect one cat.5
Ethernet cable to the radio and another cat.5
cable to a switch or PC.
Step 3
Connect the power cable supplied in the
Netkrom PoE kit to the mainelectrical supply
and the power plug into the socket of the
injector. Now, turn on your power supply.
Notice that the POWER LED has lighted up.
This indicates that the CPE is receiving
power through the NetkromPoE Injector and
that connection between your CPE and your
network has been established.
Note: Please use the PoE injector provided in
the package. Using a PoE with a different
voltage rating will damage this product.
Advertisement
Table of Contents
