Attaching The Cable Management Brackets - Cisco ASR 903 Installation Instructions Manual

Installing the Cisco ASR 903 Router as a Satellite Shelf
Step 3 Install the 8 or 12 (4 or 6 per side) 12-24 x 3/4-inch or 10-32 x 3/4-inch screws through the holes in the bracket and into
the threaded holes in the equipment rack posts.
Step 4 Use a tape measure and level to verify that the chassis is installed straight and level.

Attaching the Cable Management Brackets

To install the optional cable management brackets, perform these steps:
SUMMARY STEPS
1. Position the cable management brackets against the front of the chassis and align the four screw holes, as
shown in this figure.
2. Secure the cable management brackets with four M4 screws. The recommended maximum torque is 10
lbf/sq in.
Cisco ASR 9000 Series Aggregation Services Router Satellite Systems Installation Guide
Attaching the Cable Management Brackets
27