Attaching The Cable Management Brackets - Cisco ASR 903 Installing Manual

Installing the Cisco ASR 903 Router
Installing the Chassis in the Air Plenum
Note Ensure that the router is not installed in the Air Plenum while mounting it on the rack.
For instructions on mounting the air plenum on the rack, (see
Step 1 Position the chassis so that the rear of the chassis is at the front of the plenum. See the figure below.
Step 2 Slide the chassis into the plenum so that the front of the chassis is in flush with the mounting rails and brackets.
Figure 14: Cisco ASR 903 Chassis with Air Plenum
1

Attaching the Cable Management Brackets

The router supports the following brackets:
• A903-CABLE-GUIDE
• A903-CAB-BRACKET—This bracket helps in routing the cables from the interface modules; therefore
Cisco ASR 903 router
enabling a proper cable bending radius.
Cisco ASR 903 and ASR 903U Aggregation Services Router Hardware Installation Guide
Attaching the Cable Management Brackets
Table A-2).
2 Air plenum
15