Multitest-Xt Assembly And Installation - Macmesin MultiTest–xt Assembly And Installation Manual

3. MultiTest-xt Assembly and Installation

3.1 Bolting the test stand to the work surface
In order to comply with European regulation and safe use of the equipment, single
column stands should be secured to the bench as follows:
Test stand
0.5-xt
1-xt
2.5-xt
5-xt
* For MultiTest-xt console-controlled frames we recommend that the console is located below the information
label on the mounting rail for stability. If the console is to be mounted above this point, please contact your
authorised Mecmesin agent to purchase a set of anchor brackets.
The extended-length test stands MultiTest 0.5-xt and MultiTest 1-xt are supplied with
base anchoring brackets to allow the test stands to be bolted to a bench. Screw the
anchoring brackets to the four positions on the base plate of the MultiTest 0.5-xt or 1-xt
using the M6 screws provided. Secure the test stand to the bench using suitable
fastenings.
MultiTest 0.5-xt and 1-xt are supplied with anchoring brackets
Assembly and Installation of –xt System Test Stands
Height (mm) Feet/fixing supplied
1710 Anchor brackets
1510 Anchor brackets
941 Rubber feet
1082 Rubber feet /locating eyes
Bolting recommended?
Yes
Yes
No*
Yes
Mecmesin  3