Vortex-Xt Assembly And Installation - Macmesin MultiTest–xt Assembly And Installation Manual

4. Vortex-xt Assembly and Installation

4.1 Fitting the console to the Vortex-xt
Using the Allen key supplied, fit the stand bracket to the right-hand column as shown,
and adjust the height. The console is supplied assembled onto a mounting bracket. This
needs to be attached to the stand bracket with the two supplied security screws, and the
Torx wrench provided. Note: Do no use any other tools other than those provided.
Support the console with one hand and, with the top screw held in place by the supplied
Torx wrench, locate the console on the stand and engage the screw. When almost tight, fit
the lower screw. Tighten both and release the console.
Fit and adjust height of the bracket Attach the console to the bracket
The angle and rotation of the console are locked into set positions by sprung pins. Slacken
the appropriate knob and reposition the bracket or arm on alternative pin locations, as
shown above for single column stand assembly.
4.2 Fitting the crosshead to the Vortex-xt
Slide the crosshead onto the two support columns and tighten both securing thumb-screws.
Different height samples can be accommodated by moving the complete crosshead up
and down. Additional adjustment is available by moving the top-load carrier.
Mecmesin  11
Assembly and Installation of –xt System Test Stands