Twin Column Stands With Guards - Macmesin MultiTest–xt Assembly And Installation Manual

below. This needs to be attached to the slot using the supplied Torx wrench. Note: Do no
use any other tools other than those provided.
Slacken the two nuts off and align then vertically to fit into the slot. Support the console
with one hand and, with the top screw held in place by the Torx wrench, locate the
bracket over the slot and engage the screw. This will rotate the 'T' nut and engage in the
slot. When almost tight, turn the lower screw. Tighten both and release the console.
Height can now be adjusted by supporting the console and slightly slackening the nuts to
move the console up or down.
Twin column mounting plate and tool Fit the 'T' nuts into the rear slot and tighten
The angle and rotation of the console are locked into set positions by sprung pins. Slacken
the appropriate knob and reposition the bracket or arm on alternative pin locations, as
shown above for single column stand assembly.

3.4.1 Twin column stands with guards

Where a twin column stand is fitted with a guard cabinet, the console may be fitted to the
frame. A mounting plate will be already fitted; secure the console bracket to the rear of
the plate using the two screws provided. Height may be adjusted by slackening the
mounting plate screws slightly, and retightening at the appropriate height.
Supporting the console, slacken the screws and adjust the height.
6  Mecmesin
Assembly and Installation of –xt System Test Stands