Sleep Mode And Nap Modes; Using The Aux-In Jack To Listen To Audio - Altec Lansing timeMachine IMW465 Owner's Manual

Sleep Mode and Nap Modes

While listening to an audio source, you can program your device to power off after a set amount of time.
1. To choose what duration of time should pass before your unit powers off, press the TIME SET button while
audio is playing. Press the TIME SET button repeatedly to choose a duration of either 120, 90, 60, 45, 30, 20,
10 or 5 minutes or 00 (OFF) until your unit powers off.
2. To set Nap time, press and hold the MODE Button then press MODE Button again as needed to cycle to the
desired nap duration: 120, 90, 60,45, 30, 20, 10 or 5 minutes or 00 (OFF) (turns the nap alarm off).

Using the AUX-In Jack to Listen to Audio

You can use your device to listen to a Bluetooth audio source, or you can connect an audio source directly to
your device via the Aux-In jack.
1. Connect one end of a standard 3.5mm audio cable into the aux-in jack on the rear of your device. Connect
the other end into the headphone or output jack of your audio device.
2. Press the POWER button on the unit to power it on.
3. Press the MODE button repeatedly until the AUX icon appears on the display screen.
4. Press the VOL + or VOL- buttons to adjust the volume.
5. When done listening, press the POWER button to turn the unit off. Remember to turn off your audio device,
as well to avoid wasting battery power.