Altec Lansing Shockwave 100 IMT7001 - Wireless Party Speaker Manual

Also See for Shockwave 100:

Quick start manual (12 pages)

Quick start manual (12 pages)

Table of Contents

Contents

1 WHAT'S INCLUDED
2 INPUT/OUTPUT PORTS
3 SPEAKER CONTROLS
4 CONTROL PANEL
5 BLUETOOTH CONNECTION
6 LIGHTING CONTROL
7 SPECIFICATIONS
8 SAFETY PRECAUTIONS
9 Documents / Resources
- 9.1 References
- 9.2 Download manual

Altec Lansing Shockwave 100 IMT7001 - Wireless Party Speaker Manual

WHAT'S INCLUDED

INPUT/OUTPUT PORTS

SPEAKER CONTROLS

Brief introduction to buttons on top panel
SPEAKER CONTROLS

MIC Volume Control:
Press MIC volume buttons to increase or decrease the volume of each microphone
Power Button:
Press and hold for 3 seconds to turn speaker ON and OFF

CONTROL PANEL

BLUETOOTH CONNECTION

Go to the Bluetooth settings page on your phone. Make sure Bluetooth is on before connecting to the available device "AL Shockwave 100".
BLUETOOTH CONNECTION

Stereo pairing (requires two speakers):

Have one speaker turned on, paired, and playing music. It will serve as the HOST (the Primary speaker). The display will be showing 'Bt'. (Pair by pressing the BT/PAIR button, 'Bt' flashes on the display screen and becomes solid when pairing is complete.
Turn on an additional compatible speaker, it will serve as the Secondary speaker.
Press and hold the BT/PAIR button on the Primary speaker for approximately two seconds or until the display changes from solid 'Bt' to flashing 'HOST'.
Quicklypress the BT/PAIR button on the Secondary speaker. The displaywill changefrom flashing 'Bt' to flashing 'St PAIR' (stereo pairing).
The speakers will connect and both displays will show 'Bt'. The speakerswill now play the same music from the same audio source, one will play Left and one will play Right.

LIGHTING CONTROL

Briefly press the LIGHTS button for lighting control:
(Noted: Cone's light will be displayed while unit is playing music)

LED 1: Side lights scrolling multi-color, cones color change with the beat; press and hold to change as single color scrolls one by one.
LED 2: Sides and cones follow music and change color automatically every 3 seconds.
LED 3: Side lighting one colore, cones follow music to flash the same color; press and hold for 3 seconds to change color.
LED 4: Sides off and cones flash into one color; press and hold for 3 seconds to change color.
LED 5: Sides do a bar graph from the middle in one color and cones flash the same color; press and hold for 3 seconds to change color.
LED 6: Sides and cones slowly change colors automatically every 3 seconds; press and hold to turn the cone lights off.
LED 7: Sides flash one color and cones are off. Press and hold for 3 seconds to change color.
LED 8: Sides do a multi-color bar graph from the middle and cones flash.
LED 9: Sides fade between colors and cones are off.
OFF:Lighting off.