Water Tray Removing/Installing; Instructions For Regular Cleaning; Instructions For Removing And Cleaning The Ice Bank - Hitachi R-M800GP2M Instruction Manual

Ice Bank
Before performing maintenance, make sure that the refrigerator is unplugged.

Instructions for Regular Cleaning

1. Wipe the Ice Bank dry with a soft cloth.

Instructions for Removing and Cleaning the Ice Bank

1. Grasp the top of the Ice Bank with both hands.
Then, lift it up and pull it towards yourself.
3. When installing the Ice Bank, be sure that there
is no gap at the bottom of the Ice Bank.
GAP
If there is a gap, rotate the Auger 90 degrees and then install the Ice Bank.
Warning
Caution
Water Tray
If the Water Tray becomes soiled, remove it and rinse it off.
1. To remove the Water Tray, pull it forward.
Wipe up any water or debris in the dispenser pit (especially the bottom) with a soft cloth.
90
Be careful, as the Ice Dispenser rotates and may cause injury.
Before performing maintenance, make sure that the refrigerator is unplugged.
Do not put your hands inside the Ice Bank.
Do not use the Ice Dispenser when the Ice Bank is removed from the refrigerator.
Do not disassemble, repair, or modify this equipment.
When repairs are necessary, contact retailers or service center.
Do not touch the blades of the Ice Bank when it is removed. There is a risk of injury.
2. After removing the ice, wipe the Ice Bank with a soft cloth,
being careful to remove any water in or on the Ice Bank.
If there are still ice cubes remaining in the Crusher Case in the
reverse side of the Ice Bank, remove them using a spoon, etc..
Auger
2. To install the Water Tray, insert the tabs (2 tabs) on the
back side first, then insert the tabs on the front side (3 tabs)
securely.
Booth
Tap
Water Tray
Tap
Flapper
Crusher Case
Blade
19