Table of Contents
Advertisement
The initial settings
For proper operation, it is necessary to perform the initial setup of network parameters. Be sure
to provide reliable quality connection between the DVK-300HD, and the PC on which the control
application is installed, in particular in the case of firmware upgrade.
• IP network address assigned by manufacturer: 192.168.1.10.
• The default device name is DataVideo ChromaKey
1.
If you are working with a single device, you can connect it directly with a network cable. PC
where is running the application should be set to the IP address of the same subnet 192.168.1.X
(e.g. 192.168.1.5)
2.
If you are working with multiple devices DVK-300HD, it is possible to connect each device with
a network cable to the router. In this configuration, the PC where is running the application,
should belong to the same subnet (connected to the router).
2.1
Dynamic IP adress assignment
After connecting the power and network cable, each of the devices by 30 seconds automatically
attempts to retrieve the IP address of the network in accordance with the principle of dynamic al-
location of IP addresses your router. When it fails, the IP address of the device is set to the default
value (192.168.01.10). In this case, check the quality of the network cable connections and repeat
the procedure again by disconnecting and reconnecting the power cord to the device
2.2
Static IP address assignment
•
open the application DVK-300HD Chroma Key
•
select a device from the list of available devices
select the Configuration button located at the bottom right of the main window.
•
•
select the Change button in the Network configuration
6
DVK-300HD
Section of network parameter settings
Drawing 1.
Advertisement
Table of Contents
