Power-Up Config - Printronix SL5000r Quick Setup Manual

Power-Up Config.

You can specify the Factory configuration or any one of the eight
possible saved configurations as the power-up configuration.
The default is Factory.
SMT: Status
This menu appears only if an RFID encoder is installed. Refer to
"Software Migration Tools (SMT)" in the RFID Labeling Reference
Manual .
•
Disabled.The printer disables the use of the Software
Migration Tools.
•
Enabled. The printer enables the use of the Software Migration
Tools.
SMT: Sel Toolset
This menu appears only if an RFID encoder is installed. Refer to
"Software Migration Tools (SMT)" in the RFID Labeling Reference
Manual .
•
Toolset [1]. SMTs for PGL emulation.
•
Toolset [2]. SMTs for PPI/ZGL emulation.
•
Toolset [3] and Toolset [4]. Reserved for internal use and
future design.
SMT: Select Tool
This menu appears only if an RFID encoder is installed. Refer to
"Software Migration Tools (SMT)" in the RFID Labeling Reference
Manual .
•
EPC, GTIN, UPCA, EAN8, EAN13, and UCC128. SMTs
displayed if Toolset [1] is selected under SMT: Sel Toolset.
•
zEPC, zGTIN, zUPCA, zEAN8, zEAN13, and zUCC128. SMTs
displayed if Toolset [2] is selected under SMT: Sel Toolset.
NOTE: Undocumented options are reserved for internal use and
future design.
QUICK SETUP Menu Items
49