Getting Started - Garmin Delta Inbounds Owner's Manual

Getting Started

See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
The dog collar device and wireless containment system are not
recommended for use with aggressive dogs. Do not use this
product if your dog is prone to aggressive behavior. The device
is not designed or intended to restrain aggressive dogs. The dog
collar device and wireless containment system should be used
at the dog owner's discretion. Consult your veterinarian or a
certified dog trainer to determine if this product is right for your
dog.
Setting Up the Delta Inbounds System
Complete these tasks to set up the Delta Inbounds system.
1
Charge the dog collar device
Device, page 1).
2
Install backup batteries in the base unit
Batteries, page 1).
3
Select a mounting location, and install the base unit
(Installing the Base Unit, page
4
Set up a boundary (Setting up a Boundary, page
5
Train your dog to use the wireless containment system
(Training Your Dog to Use the Boundary, page
Device Overviews
Base Unit
Keypad
Battery cover D-ring
Power port
Mini-USB port (under battery door)
Keypad
OK Select to choose menu options.
Select to return to the previous screen.
Select to scroll through menus, options, and screens.
Dog Collar Device
Getting Started
WARNING
WARNING
(Charging the Dog Collar
(Installing Backup
2).
2).
4).
Power key
Status LED
Contact points
Charging clip contacts
Collar band
Charging the Dog Collar Device
To prevent corrosion, thoroughly dry the contacts on the dog
collar device and the surrounding area before connecting the
charging clip.
You should fully charge the battery before you use the device for
the first time. Charging a fully depleted battery takes about three
hours.
1 Snap the device onto the charging clip
2
Plug the power cable into a power source.
The status LED is solid red when the device is charging.
3
After the status LED turns solid green, remove the charging
clip from the device.
Turning On the Dog Collar Device
Hold the power key until the status LED turns green and the
device beeps.
Turning Off the Dog Collar Device
Hold the power key until the status LED turns solid red and
the device beeps.
Installing Backup Batteries
The base unit uses three AA batteries (not included). You
should install backup batteries in the base unit to maintain an
active boundary during a power outage.
1
Turn the D-ring counter-clockwise, and pull up to remove the
cover.
2
Insert three AA alkaline batteries, observing polarity.
3
Replace the battery cover, and turn the D-ring clockwise.
Mounting Location Considerations
• The base unit should be approximately 1.5 m (5 ft.) above the
ground when mounted.
• The base unit should be near a power source.
NOTICE
.
1