Table of Contents
Advertisement
Safety Instructions For Power Tools
9. USE PROPER EXTENSION CORD. Make
sure your extension cord is in good condi-
tion. Conductor size should be in accor-
dance with the chart below. The amperage
rating should be listed on the motor or tool
nameplate. An undersized cord will cause
a drop in line voltage resulting in loss of
power and overheating. Your extension
cord must also contain a ground wire and
plug pin. Always repair or replace exten-
sion cords if they become damaged.
Minimum Gauge for Extension Cords
AMP RATING
0-6
7-10
11-12
13-16
17-20
21-30
10. WEAR PROPER APPAREL. Do not wear
loose clothing, gloves, neckties, rings,
bracelets, or other jewelry which may get
caught in moving parts. Non-slip footwear
is recommended. Wear protective hair cov-
ering to contain long hair.
11. ALWAYS USE SAFETY GLASSES. Also
use face or dust mask if cutting operation
is dusty. Everyday eyeglasses only have
impact resistant lenses, they are NOT safety
glasses.
12. SECURE WORK. Use clamps or a vise to
hold work when practical. It's safer than using
your hand and frees both hands to operate
tool.
13. DO NOT OVER-REACH. Keep proper
footing and balance at all times.
14. MAINTAIN TOOLS WITH CARE. Keep
tools sharp and clean for best and safest
performance. Follow instructions for lubri-
cating and changing accessories.
15. USE RECOMMENDED ACCESSORIES.
Consult the owner's manual for recom-
mended accessories. The use of improper
accessories may cause risk of injury.
G1023S/G1023S110 Heavy-Duty 10'' Table Saw
LENGTH
25ft
50ft
100ft
18
16
16
18
16
14
16
16
14
14
12
12
12
12
10
10
10
No
16. REDUCE THE RISK OF UNINTENTIONAL
STARTING. On machines with magnetic
contact starting switches there is a risk
of starting if the machine is bumped or
jarred. Always disconnect from power
source before adjusting or servicing.
Make sure switch is in OFF position before
reconnecting.
17. MANY WOODWORKING TOOLS CAN
"KICKBACK" THE WORKPIECE toward
the operator if not handled properly. Know
what conditions can create "kickback" and
know how to avoid them.
18. CHECK DAMAGED PARTS. Before fur-
ther use of the tool, a guard or other
part that is damaged should be carefully
checked to determine that it will operate
properly and perform its intended func-
tion. Check for alignment of moving parts,
binding of moving parts, breakage of
parts, mounting, and any other conditions
that may affect its operation. A guard
or other part that is damaged should be
properly repaired or replaced.
19. NEVER
LEAVE
UNATTENDED. TURN POWER OFF. Do
not leave tool until it comes to a complete
stop.
20. NEVER OPERATE A MACHINE WHEN
TIRED, OR UNDER THE INFLUENCE
OF DRUGS OR ALCOHOL. Full mental
alertness is required at all times when
running a machine.
21. NEVER
ALLOW
PERSONNEL
TO
MACHINE WHILE UNSUPERVISED.
Make sure any instructions you give
in regards to machine operation are
approved, correct, safe, and clearly under-
stood.
22. IF AT ANY TIME YOU ARE EXPE-
RIENCING
DIFFICULTIES
ing the intended operation, stop using
the machine! Then contact our service
department or ask a qualified expert how
the operation should be performed.
TOOL
RUNNING
UNTRAINED
OPERATE
THE
perform-
-3-
Advertisement
Table of Contents
