Printek Mobile Thermal Printer MtP300 Series Operator's Manual page 38

Printer Configuration
Truncate Lines
Possible Values: No*, Yes
This feature specifies what is to be done with data that will not fit within the printable area of the current
Format. The printable area is defined as the printable line length of the print head (approximately 4.1 inches)
minus the area specified by the left and right margin.
When printing text, a value of "No" will cause excess data to be "wrapped around" and printed at the beginning
of the next line. A value of "Yes" will cause the excess data to be discarded.
When printing graphics, excess data will always be discarded.
Print Promotion
Possible Values: No*, Yes
This feature is only available in firmware version 2.8 or later.
When set to "Yes" this feature causes a previously stored graphic image with an ID value of "$" to be printed at
the end of each print job.
This feature may be used to print a special logo or graphic image of a special sales promotion or other event,
that also needs to be enabled/disabled by the user in the field.
Note: In firmware version 2.9 and later, multiple graphic images may be stored with the ID values of "!",
"@", "#", "$", "%", "^", "&", "*", "(", and/or ")". In this case, the printer will automatically cycle
through each of these images printing one at the end of each print job.
Please refer to the MtP Series & FieldPro Programmer's Manual for more information on storing graphics and
logos.
32
Truncate Lines
No
Print Promo
No