Bluetooth Interface - Printek Mobile Thermal Printer MtP300 Series Operator's Manual

Bluetooth Interface

INTERFACE MENU
Bluetooth
Note that "Bluetooth" must be displayed on the bottom line of the display in order to access the following
features and for this interface to be active when Setup is exited.
Emulation
Possible Values: Printek*, O'Neil, ZPL-II, Mt3, CPCL, Hex Dump
This feature sets the family of printer commands that may be used by a host application program to control the
various capabilities of the printer. The printer will only respond to commands valid for the currently selected
emulation. For more information, please refer to the MtP Series & FieldPro Programmer's Manual.
Note: After pressing the
and display "Waiting for Bluetooth" while reading the current configuration from the Bluetooth
interface module.
Pairing Mode
Possible Values: Paired*, Unpaired
This feature allows Bluetooth pairing to occur between the printer and the connecting device whenever Security
is required by either device. Pairing requires that the PIN on the printer and the connecting exactly match each
other.
Role Policy
Possible Values: Defer*, Master
Note that this feature is only available in firmware version 2.8 or later.
This feature selects the role of the printer's interface in the Bluetooth network.
If the device attempting to communicate with the printer is having trouble discovering the printer, setting the
value to Master may correct the problem.
Emulation
Printek
Enter Button to move from Emulation to Pairing Mode, the printer will pause
Pairing Mode
Paired
Role Policy
Defer
Printer Configuration
25