Vertical Position - Printek FormsMaster 8000se Series Programmer's Manual

Vertical Position

Line Feed
Causes the current line to be printed and then advances the paper one line at the current line spacing. If
"Auto CR" is set to "On" in the interface setup menu, a carriage return will also be performed.
Control Code:
Hexadecimal
Escape Sequence:
Hexadecimal:
Index
Advances the paper to the next line. The current column is not changed, regardless of the status of auto CR
on LF.
Control Code:
Hexadecimal:
Next Line
Causes the current line to be printed, and then sets the current print position to the left margin and performs a
line feed. Equivalent to a carriage return (CR) line feed (LF) combination.
Control Code:
Hexadecimal:
Escape Sequence:
Hexadecimal:
Vertical Position Absolute
Moves the current print position to p decipoints from the top of the form.
The following example advances the paper to 2 inches below top of form.
Example: ESC [1440d
Escape Sequence:
Hexadecimal:
Vertical Position Relative
Advances paper p decipoints. This command enables printing below the bottom margin of the current form
and above the top margin of the following form. The example below advances the paper 4 ¼ inches.
Example: ESC [3060e
Escape Sequence:
Hexadecimal:
LF
0A
ESC D
1B 44
IND
84
NEL
85
ESC E
1B 45
ESC [ 1
1B 5B 31
ESC [ 3
1B 5B 33
Genicom 3840 and 3410 ANSI Emulation
4 4 0
34 34 30
0 6 0
30 36 30
ESC D
IND
ESC E
ESC [(p)d
d
64
ESC [(p)e
e
65
115