Loading Paper; Printmaster 850 Single Tractor Model - Printek 850 Series Operator's Manual

Loading Paper

When shipped from the factory, the basic configuration for all ten forms is
an eleven-inch form, six lines per inch, and ten characters per inch. If the
forms you are loading do not match these requirements, please refer to the
printer Configuration" chapter on page 34 and review the "
" and "
Setup Forms Menu
Please refer to the appropriate section below for loading paper in the
PrintMaster 850/850si, or PrintMaster 852si.
PrintMaster 850/850si Single Tractor Model
Loading the Form in the Tractors
1. Open the paper door (rear lid) of the printer. This will provide access
to the tractors as shown below.
2. Open the tractor doors and remove the old form.
3. If the new form is a different width than the previous form, unlock the
right tractor and move it to approximately the new position.
Note: The left tractor position is fixed and may not be moved.
1 2
" sections.
PrintMaster 850 tractors
G E T T I N G S T A R T E D
Introduction To