Logitech PM5 User Manual page 2

Lapping & Polishing System Logitech PM5 user manual 2017/05/08
Fig. 2
• PP6 jig: sample holder. Samples are held by vacuum.
Be sure to hold up the central ring with your fingers
before you put it down,
• Dial gauge: to measure the load added to the
sample,
• Load adjuster: to adjust the load
Fig. 3
• Sample fixing tool,
• Hot plate,
• Ceramic plate: holder on witch the sample is fixed.
Diameter is 105mm,
• Teflon block: used when fixing the sample on the
ceramic plate.
• Trap: to prevent the suction of slurry
• Leak valves
• Load gauge: to measure the load added to the
sample,
• Glass plate: used with the load gauge,
• Jig holder: a tool used to hold the jig face up when
setting the sample on it,
• Vacuum hose.
2 / 7
Fig. 6
Fig. 7
Fig. 8