Address' Dip Switches - Re-Verber-Ray MP-25-80N Insert Manual

MP Series
Standard Configuration: From the factory, the heater is configured as follows:
'Master' Heater: ON
1
Outdoor Air Probe: OFF
2
Premium User Interface: ON
3
Potentiometer: OFF
4
Thermostat: OFF
5
Economy Mode: OFF
6
Standard Mode: ON
7
Comfort Mode: OFF
8
MASTER DIP SETTINGS
Figure 2.7 • Standard Configuration of DIP Switches
*If outdoor air sensor is equipped, switch DIP#2 to the ON position.
Use Diagram "A" on Page 8 for connecting the Premium User Interface to the heater.

'Address' DIP Switches

The Address DIP Switches are only utilized in a 'Master/Slave' installation or for BMS configurations. All
SLAVE DIP SETTINGS
other configurations ignore the settings of these switches. When addressing a heater for a 'Master/Slave'
configuration, the 'Slave' heaters must be addressed for proper operation. Each 'Slave' must have its own
unique configuration, determined by the installer. Up to 256 unique combinations can be configured.
Setting the 'Slave' Heater(s): The 'Slave' heater configuration is set by selecting the 'Slave' position on
switch #1 in the "Options" DIP Switches. The address switches become active when the 'Slave'
configuration is selected. On the Address DIP Switches, configure each heater so that each heater has its
own unique configuration. An example is provided below for a three heater zone system.
Figure 2.8 • Example of three DIP Switches
Master Heater
Master Heater
(Factory Default)
COMFORT
STANDARD
ECONOMY
EXT. THERMOSTAT
POTENTIOMETER
USER INTERFACE
OA SENSOR*
MASTER
ON ON
Slave Heater
Slave Heater
(One Address Configuration)
COMFORT
STANDARD
ECONOMY
EXT. THERMOSTAT
POTENTIOMETER
USER INTERFACE
OA SENSOR*
MASTER
ON ON
15
2.0 Installation • Configuring the Heater
Slave Heater
Slave Heater
(Different Configuration)
COMFORT
STANDARD
ECONOMY
EXT. THERMOSTAT
POTENTIOMETER
USER INTERFACE
OA SENSOR*
MASTER
ON ON