Table of Contents
Advertisement
EMS Wireless
EkoLink Plus Fiber Optic DAS
Single Mode Fiber Optic
Cable(s) to Hub
AC or DC Power (depending
on option), or Battery Backup
Unit (optionally)
Diversity Receive Antenna
(optional) [N(f) connector with
1/2" coax]
Chassis Ground Screw
TX/RX Server Antenna [N(f)
connector with 1/2" coax]
3.0 System Set-up and Turn-on
The EkoLink Plus hub and remotes can be configured locally through a laptop
computer and its RS-232 serial communications port. Once the system is configured, it
can be controlled using an optional telephone line interface.
The following is a summary procedure for configuring the EkoLink Plus using its built-in
automatic software. More detailed software commands for specific configurations can
be found later in this manual.
23
EkoLink Plus Remote Connections
(See Optional Battery Backup
Instructions for Detailed
Connections)
Div RX Ant
Figure 9: Remote Unit Connections
Antenna
AC Main
Fiber
Install FO jumper with single
FC connector to FO
transceiver.
Fusion splice jumper to FO
cable from hub.
Repeat for diversity RX
connection, if used.
Use optional pull box to
protect splices and coil up
excess cable.
Fiber Optic Connections
Inside Remote Unit
Operator's Manual
Advertisement
Table of Contents
