Advertisement
Quick Links
Advertisement
Related Manuals for Grainfather Connect Control Box
Summary of Contents for Grainfather Connect Control Box
- Page 1 Grainfather Connect Control Box Instructions...
- Page 2 Safety Information 1. This controller is only to be used with the Grainfather brewing system, do not use with any other product. 2. Only use the product in the country that the control box is specified for. 3. Make sure to not splash any water into the air vents on the side of the control box or from the bottom of the control box.
- Page 3 One phone connects with one Grainfather. Make sure you are the only one connecting to your Grainfather. If you are brewing with someone who also has a Grainfather, one person must connect first. The other person should keep their control box turned off until the first person has connected successfully, before turning it on to connect themselves.
- Page 4 IMPORTANT TO NOTE: plug, the plug exiting the boiler base is the heating element plug. If you have an Element Variation Switch on your Grainfather - you NOTE: You are likely to want to should now ensure this switch is always set to ‘Normal’ and leave your lift the unit up to insert this, but control box to control the heating.
- Page 5 MANUAL Operation & Features Button Press Once Hold for 3 Seconds Hold for 6 Seconds Pump Pump On/Off (It will light up when on) Heat Heat On/Off (It will light up when on) Go straight to boil /sets target temperature to 100°C (212°F) Turn Off Alarms Set timer (hold until timer unit flashes then...
- Page 6 Delayed Heating This setting is so you can set the Grainfather to begin heating when you want to eg in 7 hours. 1. Press the up or down arrows to set 2. Press the “Set” button to toggle 3.
- Page 7 Step Mashing In this mode your can program up to four steps into the control box. 1. Choose how many steps you need 2. Press up or down to change 3. Press “Set” to switch to edit time. by pressing up arrow, then press temperature.
- Page 8 FCC Statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 9 www.grainfather.com...
Need help?
Do you have a question about the Connect Control Box and is the answer not in the manual?
Questions and answers