Table of Contents
Advertisement
Basic Operation Instructions
Speed Dial
The GC Controller provides a speed dial to control the speed of the power
chair. See figure 3.
To change the speed:
1. Push the on/off key to power on the chair and the controller.
2. To increase your speed, turn the speed dial clockwise.
3. To decrease your speed, turn the speed dial counterclockwise.
NOTE: We recommend that the first few times you operate your power
chair, you set the speed to the slowest setting until you become familiar
with your new power chair.
Battery Condition Meter
The battery condition meter consists of five LEDs arranged in an arc over
the on/off and horn keys. See figure 1. When functioning as the battery con-
dition meter, this indicates the status of the electrical system using LED
codes. For example, as the battery voltage drops, the number of LEDs
reduces from right to left. When the battery capacity drops to 10% or below,
the left red LED will flash.
Battery condition meter codes are as follows:
Left Red LED Flashing Slowly or Steady: Battery charge is low;
charge the batteries as soon as possible.
LEDs Scroll from Left to Right: The controller is in inhibit or charging
mode.
Side-to-Side Double LED Ripple Followed by All LEDs Flashing
Quickly: The joystick was not in the center position when the power
was switched on, or the controller system detected a fault; refer to the
Fault Code Table.
www.pridemobility.com
13
GC Controller
Advertisement
Table of Contents
