Starting A Programme - AEG FEE92800PM User Manual

Table of Contents

Advertisement

14
www.aeg.com
The basket is automatically locked on the
upper level. Load or unload the basket
carefully (refer to basket loading leaflet).
2. To lower the basket connect the
release handle with the basket frame
as shown below. Lift the release
handle and the rack up.
Once the release handle is lifted,
push the rack down. The mechanism
returns to its basic position on the
lower level.
There are two ways of lowering the
basket depending on the loading:
• If there is a full load of plates
slightly push the basket down.
• If the basket is empty or half-
loaded press the basket down.
9.2 Using the detergent
A
B
C
CAUTION!
Only use detergent
specifically designed for
dishwashers.
1. Press the release button (A) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (B).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the lid
locks into position.
9.3 Setting and starting a
programme
The Auto Off function
This function decreases energy
consumption by deactivating
automatically the appliance when it is not
operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has
not started.

Starting a programme

1. Press the on/off button to activate
the appliance. Make sure that the
appliance is in programme selection
mode and the door is closed.
2. Press Program again and again until
the indicator of the desired
programme is on.
The display shows the programme
duration.
3. Set the applicable options.
4. Press Start to start the programme.
• The indicator of the running
phase is on.
• The programme duration starts to
decrease with steps of 1 minute.
Starting a programme with
delay start
1. Set a programme.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents