Seatback Angle Adjustment; Armrest Width Adjustment; Armrest Angle Adjustment; Armrest Height Adjustment - Pride Quantum 614 Owner's Manual

V . C O M F O R T A D J U S T M E N T S

Seatback Angle Adjustment

If your power chair is equipped with an adjustable seat-
back, you can adjust it to four (4) different angles: 90°,
102°, 105°, or 107°.
To adjust the seatback angle:
1. Remove the adjusting screws from each seat hinge.
See figure 16.
2. Set the seatback at the desired angle.
3. Reinstall the adjusting screws to each seat hinge
and tighten.

Armrest Width Adjustment

You can change each armrest's width independently of
the other.
NOTE: Changing the armrest width may increase the
overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the
armrest receiver bracket. See figure 16.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.

Armrest Angle Adjustment

To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicu-
lar to the floor. See figure 16.
2. Loosen the jam nut.
3. Turn the adjusting screw to raise or lower the front
of the armrest.
4. Tighten the jam nut to lock the adjusting screw into
place.

Armrest Height Adjustment

To change the armrest height:
1. Loosen the two setscrews located on the armrest
receiver. See figure 16.
2. Raise or lower the armrest to the desired height.
3. Tighten the setscrews to secure the armrest.
26
JAM NUT
ARMREST ANGLE
ADJUSTING SCREW
ARMREST
HEIGHT
ADJUSTING
SETSCREWS
SEATBACK ANGLE
ADJUSTING SCREW
ARMREST
KNOB
Figure 16. Seatback/Armrest Adjustment
www.pridemobility.com Quantum 614 Series