Default Settings - Cisco Nexus 9000 Series Configuration Manual

Configuring VTP
• In SNMP, the vlanTrunkPortVtpEnabled object indicates whether the VTP feature is enabled or not.

Default Settings

This table lists the default settings for VTP parameters.
Table 5: Default VTP Parameters
Parameters
VTP
VTP Mode
VTP Domain
VTP Version
VTP per Interface
Configuring VTP
You can configure VTP on Cisco Nexus 9000 devices.
VLAN 1 is required on all trunk ports used for switch interconnects if VTP is used in transparent mode
Note
in the network. Disabling VLAN 1 from any of these ports prevents VTP from functioning properly in
transparent mode.
VTP worked only in transparent mode.
Note
Procedure
Step 1
The status of the vlanTrunkPortVtpEnabled object aligns with the output of the show vtp trunk interface
eth a/b command.
Command or Action
config t
Example:
switch# config t
switch(config)#
Cisco Nexus 9000 Series NX-OS Layer 2 Switching Configuration Guide, Release 7.x
Default Settings
Default
Disabled
Transparent
blank
1
Enabled
Purpose
Enters configuration mode.
39