Fuji Electric PXR4 Instruction Manual page 35

[Table 5]
Parameter :
[MOD code list]
MOD Power ON start
0 Without
1 Without
2 Without
3 Without
4 Without
5 Without
6 Without
7 Without
8 With
9 With
10 With
11 With
12 With
13 With
14 With
15 With
[Description of functions]
1. Power ON start: Starts ramp/soak with the current PV value.
2. Output at END: Displays the output status at the time when ramp/soak is at END.
3. Output at OFF: Displays the output status at the time when ramp/soak is at OFF.
4. Repeat operation: After the ramp/soak step is terminated once, runs ramp/soak repeatedly.
The PV value set in the previous step is maintained in normal state (without repeat operation).
* Standby mode: Output -3%
Alarm OFF
Standby mode where no control operation is performed.
Control operation type code
Output at END
Control continued Control continued
Control continued Control continued
Control continued
Control continued
Standby mode Control continued
Standby mode Control continued
Standby mode
Standby mode
Control continued Control continued
Control continued Control continued
Control continued
Control continued
Standby mode Control continued
Standby mode Control continued
Standby mode
Standby mode
Output at OFF Repeat operation
Without
Standby mode Without
Standby mode
Without
Standby mode Without
Standby mode
Without
Standby mode Without
Standby mode
Without
Standby mode Without
Standby mode
– 35 –
With
With
With
With
With
With
With
With