Fuji Electric PXR4 Instruction Manual page 14

Press the SEL for 2 sec.
3
Shift to operating condition
Operation mode
Parameter setting procedure
Select a parameter you want to
1
set by pressing the or
key.
Press the key to allow the
2-1 SEL
parameter to change.
(Under the changing condition,
the parameter set value flickers).
Pressing the or key, to
2-2
change the parameter set value.
After the parameter has been
2-3
changed, press the key
SEL
for registration.
To shift to Operation/Standby
3
mode, press the key for 2 sec.
SEL
Note: If the upper display (PV) comes off (or kept distinguished), make the setting once again by adding 64 to the set value of parameter DP13.
Parameter setting mode
1
Parameter selection
C1 C2 AL1 AL2 AL3
PV
SV
SEL
PXR-4
Parameter search.
Press the . Press the
C1 C2 AL1 AL2 AL3
PV
SV
SEL
PXR-4
By repeating the same procedure, the
parameters can be displayed according to the
parameter list shown in 5, Setting methods of
temperature and parameters.
– 14 –
2
Parameter settings
C1 C2 AL1 AL2
PV
Press the
once.
SEL SV
SEL
PXR-4
Parameter change.
Increases parameter
set value
.
Decreases parameter
set value
SEL
Registers parameter set value,
returning to the parameter
shift mode .
1
Switching by
the
SEL
AL3
key