Fuji Electric PXR4 Instruction Manual page 33

[Table 3]
Parameter :
Input signal type
RTD (IEC) Pt100Ω
Pt100Ω
Pt100Ω
Pt100Ω
Pt100Ω -50 to 100
Pt100Ω -100 to 200
Pt100Ω -199 to 600
Pt100Ω -199 to 850
Thermo- J 0 to 400
couple J 0 to 800
K 0 to 400
K 0 to 800
K 0 to 1200
Note 1) Except for the following, the input accuracy is ±0.5% FS ±1 digit ±1°C (Input accuracy
does not be guaranteed for the ranges of measurement other than in the table above.)
R thermocouple 0 to 500 °C
B thermocouple 0 to 400 °C
Note 2) In case a measuring range of
bulb input, temperatures below
"LLLL" does not appear despite a continuous fall below
Note 3) If the resistance bulb or thermocouple is used at a temperature below the lowest value
in the measurement range, the input accuracy cannot be guaranteed.
Note 4) Addition of decimal point is impossible if the input range or span is larger than 999.9 at
the RTD/thermocouple input.
Input range (Standard range)
, ,
Range
Range
(°C) (°F)
0 to 150 32 to 302
0 to 300 32 to 572
0 to 500 32 to 932
0 to 600 32 to 1112
-58 to 212
-148 to 392
-328 to 1112
-328 to 1562
32 to 752
32 to 1472
32 to 752
32 to 1472
32 to 2192
in these ranges, this controller may display an incorrect
:
process value due to the characteristic of the sensor.
199 to 600 °C or
-
199 °C does not be indicated correctly. Therefore,
-
Input signal type
Thermo- R
couple B
S
T -150 to 200
T -150 to 400
E
E -150 to 800
N
PL-II
DC voltage 1 to 5VDC
199 to 850 °C is used for resistance
-
199 °C.
-
– 33 –
Range
Range
(°C) (°F)
0 to 1600 32 to 2912
0 to 1800 32 to 3272
0 to 1600 32 to 2912
-238 to 392
-238 to 752
0 to 800 32 to 1472
-238 to 1472
0 to 1300 32 to 2372
0 to 1300 32 to 2372
-1999 to 9999
(Scaling is possible)
• Maximum span : 9999
• Lower limit : -1999
• Upper limit : 9999