Table of Contents
Advertisement
F6. Buffer: None/Small/Large
The configuration of Ethernet interface buffer.
5.2.7
Self Test Info
G1. S-Test: Start/Testing
Activate Self Test function/Self Test status display. After activating this function, system will automatically
perform IF-Loopback, RF-Loopback and RMT-Loopback tests and display test results in "S-Test Result" menu.
The test procedure explains as following: the system would perform IF loopback test first and choose the
first tributary to send PRBS. If error number within 30 seconds is 0, then it will display "IF-LP:OK".
Figure 5-60 Speed:None/10M/100M
Figure 5-61 Buffer:None/Small/Large
Figure 5-62 Self Test Info
5-27
Interface
E1 Spread Spectrum Radios
Advertisement
Table of Contents
