Cable Connections - ATEN CS1922M User Manual

1. Important safety information regarding the placement of this
device is provided on page 39. Please review it before
proceeding.
2. Make sure that power to all the devices you will be installing has
been turned off. You must unplug the power cords of any
computers that have the Keyboard Power On function.

Cable Connections

To set up your installation, refer to the installation diagram on the following
page (the numbers in the diagram on page 11 correspond to the steps below),
and do the following:
1. Plug the USB keyboard and USB mouse into the USB console ports
located on the unit's rear panel.
2. Plug the console monitor into the DisplayPort and/or HDMI port located
on the unit's rear panel and power on the monitor(s). For multiple monitor
setups, see Display Modes, on page 16.
3. Plug the main microphone and speakers into the console microphone and
speaker jacks located on the unit's front panel. The microphone and
speakers plugged into these ports have priority over those in the rear panel.
4. (Optional) Plug your secondary microphone and speakers into the console
audio ports located on the unit's rear panel.
5. Using the cables provided with this package, plug the DisplayPort, USB
3.0, microphone, and speaker connectors into their corresponding sockets
in the KVM Port section of the switch.
Note: Verify that all the plugs are in the same KVM Port sockets (all in
Port 1, all in Port 2, etc.) Each socket is marked with an appropriate
icon to indicate its function.
Hardware Setup
Chapter 2
9