Table of Contents
Advertisement
3
Setup
Appliance management is through the web UI. The instructions in this section describe how to enable and
confirm access to it.
Assumptions
Instructions are based on the following assumptions:
• Static IP addresses are reserved for network adapters as needed.
• The local administrator account for the appliance is used for first login to the web UI.
• Recommended: Complete the
Power the Appliance
Power on and boot the appliance by pressing the On/Off button on the front panel as shown below.
Log in to the Web UI
Accessing the web UI is necessary to continue to deploy and manage the appliance. The IP address for
the internal network adapter (Primary Port) is used to access the web UI.
Note: If the LAN IP address was assigned through DHCP, login to the appliance using a KVM or Monitor
and Keyboard. Login to the windows using the default username and password. Check the IP assigned to
the appliance.
To log in
1. Open the web UI in a browser:
• From a client computer on the network, default access to the appliance web UI is through a
web browser at https://ServerName|IP address:8098.
For example, if the server LAN IP address is 192.168.30.4, the web UI URL would be
https://192.168.30.4:8098
• From an RDP/KVM session on the server, access the web UI at: https://localhost:8098
2. Enter local administrator credentials when prompted.
The factory default local administrator credentials are:
User name: administrator
Password: [Celest1x]
The password is case-sensitive and the brackets are included. The "domain\administrator" user
name format may be required.
20
Resource Worksheet
in advance to expedite installation and setup.
E Series Installation Guide
Advertisement
Table of Contents
