Table of Contents
Advertisement
2
Installation
The guide provides a system administrator with concise instructions for a base deployment. The
document covers common installation requirements and is not intended to be comprehensive. Every
network environment is different, and installation for an individual organization may require either
additional or other configuration not discussed herein.
Notes
Celestix Edge administrators should have the following skills, knowledge, and consequent access
privileges:
• Server room management
• Server administration
• Networking technology
Caution:
To reduce the risk of personal injury or equipment damage, be sure that the rack
is adequately stabilized before extending a component from the rack.
Rack the Appliance
Celestix appliances are 1U and should be attached to a standard 19-inch equipment rack as follows.
1. Power down the appliance.
2. Disconnect all peripheral cables from the appliance.
3. Disconnect each power cord from the appliance.
4. In a server that uses thumbscrew rack ears, loosen the captive thumbscrews that secure the server
faceplate to the front of the rack, and then slide the server out of the rack.
5. In a server that uses quick-release latch rack ears:
a. Open the latches on both sides of the server.
b. If necessary, use a T-25 Torx screwdriver to loosen the shipping screws. The diagram below
provides a reference.
Illustration 7: Appliance Mounting
16
E Series Installation Guide
Advertisement
Table of Contents
