Connect The Appliance - Celestix E6600 Installation Manual

Connect the Appliance

Celestix appliances have up to 6 (six) network adapters and up to 2 (two) power adapters.
Connect to the Network
Once the appliance is racked, it must be connected to the network.
If an IP address will be assigned through DHCP, and then configuration for a static address is covered in
the setup wizard interfaces
Manually explains how to add the IP address to the network adapter.
To connect the appliance
1. Connect an Ethernet cable from the Primary Port (LAN1) network adapter on the Celestix
appliance to the internal network hub or switch.
2. For additional network connections, use the Secondary Port (LAN2) or 4 Network ports adapter
(LAN3 – 6) on the appliance.
The diagram below provides a reference.
Illustration 8: Ethernet Connections
Note: Hardware models vary and may look somewhat different from the example, but network
connections will be similar.
Network Interface LED indicators
When the appliance is powered on, each of the network adapters displays a pair of lights to help identify
connection speed and usage.
17
instructions. If DHCP is not deployed, the section Configure IP Address
E Series Installation Guide