Table of Contents
Advertisement
3
Filling the Engine with Oil
No Parts Required
Procedure
Important:
Your machine does not come with oil
in the engine. Before starting the engine, fill the
engine with oil.
Engine oil capacity: 0.55 L
Oil viscosity: SAE 30 or SAE 10W-30 detergent oil
API service classification: SJ or higher
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
1. Full
2. High
3. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
4. Wait about 3 minutes for the oil to settle in the
engine.
5. Wipe the dipstick clean with a clean cloth.
6. Insert the dipstick into the oil-fill tube, then
remove the dipstick.
7. Read the oil level on the dipstick
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
(Figure
Figure 7
3. Low
(Figure
oil-fill tube, wait 3 minutes, and repeat steps
3 through 5 until the oil on the dipstick is at
the correct level.
•
If the oil level on the dipstick is too high, drain
the excess oil until the oil on the dipstick is
at the correct level; refer to
Engine Oil (page
Important:
low or too high and you run the engine, you
may damage the engine.
8. Install the dipstick securely.
4
Assembling the Grass Bag
No Parts Required
7).
Procedure
1. Slide the grass-bag frame into the grass bag
(Figure
2. Position all 6 grass-bag clips over the grass-bag
frame
g188326
1. Grass-bag frame
7).
5
14).
If the oil level in the engine is too
8).
(Figure
8).
Figure 8
2. Grass-bag clip
Changing the
g209825
Advertisement
Table of Contents
