Figure - Toro 20942 Operator's Manual

Setup
1
Assembling the Handle
No Parts Required
Procedure
1. Attach the lower handle to the mower housing
with the 4 bolts, 4 flat washers, 4 split washers,
and 4 nuts

(Figure

1. Bolt (4)
2. Flat washer (4)
2. Attach the upper handle to the lower handle
using 2 handle knobs, 2 curved washers, and
2 bolts. Tighten the handle knobs securely by
hand (Figure 4).
1. Handle knob (2)
2. Curved washer (2)
3. Bolt (2)
3).
Figure 3
3. Split washer (4)
4. Nut (4)
Figure 4
4. Upper handle
5. Lower handle
3. Insert the cables into the cable clamp and attach
the cable clip to the handle as shown in
1. Cable clip
2
Installing the Recoil-Starter
Rope in the Rope Guide
g188335
No Parts Required
Procedure
Important:
To start the engine safely and easily
whenever you use the machine, install the
recoil-starter rope in the rope guide.
Hold the blade-control bar to the upper handle
9) and pull the recoil-starter rope through the rope
guide on the handle
g188346
1. Recoil-starter rope
4
Figure 5
(Figure 6).
Figure 6
2. Rope guide
Figure 5.
g189081
(Figure
g003251