Toro Recycler 20961 Operator's Manual
Toro Recycler 20961 Operator's Manual

Toro Recycler 20961 Operator's Manual

55cm lawn mower with smart stow
Hide thumbs Also See for Recycler 20961:

Advertisement

Quick Links

55cm Recycler
Model No. 20961—Serial No. 400000000 and Up

Introduction

This rotary-blade, walk-behind lawn mower is intended to
be used by residential homeowners. It is designed primarily
for cutting grass on well-maintained lawns on residential
properties. It is not designed for cutting brush or for
agricultural uses.
Read this information carefully to learn how to operate and
maintain your product properly and to avoid injury and
product damage. You are responsible for operating the
product properly and safely.
You may contact Toro directly at www.Toro.com for product
and accessory information, help finding a dealer, or to register
your product.
Whenever you need service, genuine Toro parts, or additional
information, contact an Authorized Service Dealer or Toro
Customer Service and have the model and serial numbers of
your product ready.
Figure 1
model and serial numbers on the product.
1. Model and serial number plate
Write the product model and serial numbers in the space
below:
Model No.
Serial No.
This manual identifies potential hazards and has safety
messages identified by the safety-alert symbol
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
identifies the location of the
Figure 1
(Figure
Register at www.Toro.com.
®
Lawn Mower with SmartStow
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
1. Safety-alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
This product complies with all relevant European directives.
For details, please see the separate product specific
Declaration of Conformity (DOC) sheet.
This product contains a chemical or chemicals
known to the State of California to cause cancer,
birth defects, or reproductive harm.
The engine exhaust from this product
contains chemicals known to the State of
California to cause cancer, birth defects,
It is a violation of California Public Resource Code
Section 4442 or 4443 to use or operate the engine on any
forest-covered, brush-covered, or grass-covered land unless
g185958
the engine is equipped with a spark arrester, as defined in
Section 4442, maintained in effective working order or the
engine is constructed, equipped, and maintained for the
prevention of fire.
This spark ignition system complies with Canadian ICES-002.
The enclosed Engine Owner's Manual is supplied for
information regarding the US Environmental Protection
Agency (EPA) and the California Emission Control
Regulation of emission systems, maintenance, and
warranty. Replacements may be ordered through the
engine manufacturer.
Net Torque: The gross or net torque of this engine was
2),
laboratory rated by the engine manufacturer in accordance
Form No. 3408-418 Rev B
Operator's Manual
Figure 2
WARNING
CALIFORNIA
Proposition 65 Warning
or other reproductive harm.
Original Instructions (EN)
All Rights Reserved *3408-418* B
Printed in the USA
®
g000502

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Recycler 20961 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Toro Recycler 20961

  • Page 1: Introduction

    This manual uses 2 words to highlight information. Important calls attention to special mechanical information You may contact Toro directly at www.Toro.com for product and Note emphasizes general information worthy of special and accessory information, help finding a dealer, or to register attention.
  • Page 2: Table Of Contents

    As configured to meet safety, emission, and operating requirements, the actual engine torque on this class of mower This machine has been designed in accordance with EN ISO will be significantly lower. Go to www.Toro.com to view 5395:2013. specifications on your mower model.
  • Page 3: Safety And Instructional Decals

    Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decaloemmarkt Manufacturer's Mark 1. Indicates the blade is identified as a part from the original machine manufacturer.
  • Page 4: Setup

    Setup Important: Remove and discard the protective plastic sheet that covers the engine and any other plastic or wrapping on the machine. Unfolding the Handle No Parts Required Procedure WARNING Unfolding the handle improperly can damage the cables, causing an unsafe operating condition. •...
  • Page 5: Installing The Recoil-Starter Rope In The Rope Guide

    Installing the Recoil-starter Rope in the Rope Guide No Parts Required Procedure Important: To start the engine safely and easily whenever you use the machine, install the recoil-starter rope in the rope guide. Hold the blade-control bar to the upper handle and pull the recoil-starter rope through the rope guide on the handle (Figure g188439...
  • Page 6: Assembling The Grass Bag

    Assembling the Grass Bag No Parts Required Procedure 1. Slip the grass bag over the frame as shown in Figure g201460 Figure 6 1. Full 3. Low 2. High 3. Carefully pour about 3/4 of the engine capacity of oil into the oil-fill tube.
  • Page 7: Product Overview

    Product Overview g198722 Figure 9 1. Handle 9. Cutting-height lever (4) g027258 g027258 2. Self-propel bar 10. Spark plug Figure 8 3. Blade-control bar 11. Side-discharge door 4. Adjustment knob for the 12. Oil-fill tube/dipstick self-propel drive 3. Hook the top and side channels of the bag onto the top 13.
  • Page 8: Specifications

    Specifications WARNING Fuel is harmful or fatal if swallowed. Long-term Model Weight Length Width Height exposure to vapors can cause serious injury and 20961 35 kg 152 cm 58 cm 104 cm illness. (77 lb) (60 in) (23 in) (41 in) •...
  • Page 9: Checking The Engine-Oil Level

    Checking the Engine-Oil Level Adjusting the Cutting Height Service Interval: Before each use or daily CAUTION 1. Move the machine to a level surface. If the engine has been running, the muffler will be 2. Remove the dipstick by rotating the cap hot and can severely burn you.
  • Page 10: Starting The Engine

    • Use accessories and attachments approved by the The Toro® Company only. Slope Safety • Mow across the face of slopes; never up and down. Use extreme caution when changing direction on slopes.
  • Page 11: Using The Self-Propel Drive

    Using the Self-Propel Drive bag-on-demand lever is in the recycling position, move it to the bagging position; refer to Operating the Bag-on-Demand To operate the self-propel drive, simply walk with your hands Lever (page 11). on the upper handle and your elbows at your sides, and the machine will automatically keep pace with you (Figure 16).
  • Page 12: Side-Discharging The Clippings

    Installing the Side-Discharge Chute Lift up the side door and install the side-discharge chute (Figure 20). g198723 Figure 18 1. Bag-on-demand lever (in the bagging position) • To recycle or side-discharge the grass and leaf clippings, press the button on the lever and move the lever rearward until the button on the lever pops up.
  • Page 13 2. Ensure that the cutting-height setting on the machine DANGER is 35 mm (1-3/8 inches) or higher; if it is not, raise it; Fuel is extremely flammable and explosive. A fire or refer to Adjusting the Cutting Height (page explosion from gasoline can burn you and others. 3.
  • Page 14: Operating Tips

    • Replace the blade when necessary with a Toro replacement blade. Hauling Safety • Use care when loading or unloading the machine.
  • Page 15: Cleaning Under The Machine

    Cleaning under the Machine Cleaning under the Machine in the Vertical-stow Position Service Interval: Before each use or daily 1. Set the machine in the vertical-stow position; refer to Storing the Machine in the Vertical-Stow Position (page Cleaning under the Machine Using the 12).
  • Page 16: Maintenance

    Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Important: Refer to your engine manual for additional maintenance procedures. Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Check the engine-oil level and add oil as needed. •...
  • Page 17: Servicing The Air Filter

    Servicing the Air Filter Service Interval: Yearly 1. Unclip the top of the air-filter cover (Figure 27). g201460 Figure 28 1. Full 3. Low 2. High 4. Tip the machine onto its side (so that the air filter is up) to drain the used oil from the oil-fill tube (Figure 29) or set the machine in the vertical-stow position g186256...
  • Page 18: Replacing The Blade

    Replacing the Blade Service Interval: Yearly Important: You will need a torque wrench to install the blade properly . If you do not have a torque wrench or are uncomfortable performing this procedure, contact an Authorized Service Dealer. Examine the blade whenever you run out of fuel. If the blade is damaged or cracked, replace it immediately.
  • Page 19: Adjusting The Self-Propel Drive

    Adjusting the Self-Propel Drive Whenever you install a new self-propel cable or if the self-propel drive is out of adjustment, adjust the self-propel drive. 1. Turn the adjustment knob counterclockwise to loosen the cable adjustment (Figure 33). g024443 Figure 32 g027231 Figure 33 1.
  • Page 20: Storage

    Storage 1. On the last refueling of the year, add fuel stabilizer (such as Toro Premium Fuel Treatment) to the fuel. 2. Dispose of any unused fuel properly. Recycle it according to local codes, or use it in your automobile.
  • Page 21 Notes:...
  • Page 22 Notes:...
  • Page 23 The Way Toro Uses Information Toro may use your personal information to process warranty claims, to contact you in the event of a product recall and for any other purpose which we tell you about. Toro may share your information with Toro's affiliates, dealers or other business partners in connection with any of these activities. We will not sell your personal information to any other company.
  • Page 24 – First time starts after extended period of non-use over three normal use, it will be repaired or replaced, at Toro's option, under warranty at no cost for parts and months or seasonal storage labor. Frame failure due to misuse or abuse and failure or repair required due to rust or corrosion are not covered.

Table of Contents