Table of Contents
Advertisement
7
Function of the TeleCoppler 2
7.1
Switch and Control Devices
The devices connected to the
TeleCoppler 2 can be remote
switched or remote controlled
via telephone.
For switching and controlling
devices, the following principle
of DTMF digit codes is being
used:
Device digit:
X Y Z
X Device type
0 = conventional device
Y Device number
1 to 6 (for conv. devices)
Z Function
0 = switch off
1 = switch on
# = state request
Operation
Two ringing signals are sent
Dial code number 0 0 0 0 1
Dial digits (e. g. 010)
An alarm which is activated
while a phone connection ex-
ists will be sent off not before
an existing connection has
been disconnected.
44
7 Function of the TeleCoppler 2
The device digit has 3 digits.
The device type (X) differs be-
tween conventional device (0).
The device number (Y) ranges
between 1 and 6.
The last character (Z) defines
if the device state is sup-
posed to be switched on or
off or if it is a state request (0,
1, or #). For a summary of
possible entries see table 5
on 51.
Note: While an announce-
ment is being made, the en-
tering of digits will be ignored.
Therefore, wait for the end of
the voice message before di-
aling.
Announcement
Here is the TC Plus. Please
dial the Code number.
Please dial the device num-
ber.
Device 1 is switched off.
1 If the TeleCoppler 2 is being
used within a PABX, it might
be necessary to switch the
PABX transparent to DTMF-
signals, so that the incom-
ing DTMF-signals will not be
processed by the PABX.
For further details see your
PABX operation manual.
Advertisement
Table of Contents
