Table of Contents
Advertisement
Producers and importers fulfil their responsibility for environmentally compatible recycling,
treatment and disposal both directly and by joining a collective scheme.
-
Place the oven on a surface able to support the weight, with the left side at least 50 cm
from the wall or from other appliances. In general, we recommend leaving a gap of at
least 10 cm around all the other sides for cooling, steam evacuation
maintenance/repair work by technical support. If the appliance is placed near
walls/partitions made of inflammable material (excluding the left side, which should not be
less than 50 cm from walls), we recommend applying a suitable heat-insulating material to
the wall/partition surface.
CAUTION!: In case of appliance of many ovens next to each other, as well as the above
mantioned distances, it is necessary applying a protection ( 1 Fig. 3) to avoid that the
warm air of the cooling coming by the oven on the right side (2 Fig. 3) will be breathe
in the oven on the left (3 Fig. 3) compromising its regular functioning.
DO NOT ENCASE THE OVEN INSIDE FURNITURE OR IN WALL RECESSES. DO NOT
PLACE UNDERNEATH ENCLOSED TABLES OR UNDER BENCHES.
Use a spirit-level when installing. Any level differences must be compensated using the
-
adjusting feet (turning the screws to raise or lower). Substantial level differences can have
a negative effect on the functioning of the appliance. Do not switch on the appliance
without adjusting the feet.
INSTALLATION
CAUTION!: Only qualified staff are authorized to install, maintain and put the appliance
into service.
CAUTION!: Before beginning any electrical connection work, check that the appliance
can support the technical characteristics of the power supply, by comparing them with
the specifications on the technical data plate.
ELECTRICAL CONNECTION AND EQUIPOTENTIAL BONDING
CAUTION!: The appliance is designed for connection to a voltage supply with the
characteristics shown on the technical data plate.
-
As already indicated, an isolator that connects all poles must be fitted between the
appliance and the mains power supply, and differential protection sufficient for the
nominal power specifications of the appliance (1mA per kW of power).
Instruction AGS 646-WP- rev9 english
ed.05
and for
Page 6 di 15
Advertisement
Table of Contents
