Assembly; Hooking Up The Battery - Westinghouse iGen4500 User Manual

ASSEMBLY

HOOKING UP THE BATTERY

To avoid electrics hock:
• ALWAYS connect the positive (+)
battery cable (red boot) first when
connecting battery cables.
• ALWAYS disconnect the negative (-)
battery cable (black boot) first when
disconnecting battery cables.
• NEVER connect the negative (-)
battery cable (black boot) to the
positive (+) post on the battery.
• NEVER connect the positive (+)
battery cable (red boot) to the
negative (-) post on the battery.
• NEVER touch both battery posts
simultaneously.
• NEVER place a metal tool across
both battery posts.
• ALWAYS use insulated or
nonconducting tools when installing
the battery.
NOTE: THE INVERTER COMES EQUIPPED WITH
THE POSITIVE BATTERY CABLE (RED BOOT)
ALREADY ATTACHED.
1. Unclip the battery access panel on the back of the
unit next to the muffler (see Figure 1).
Figure 1: Battery Service Panel
6 | Westinghouse Portable Power
WARNING
2. Verify the positive (+) battery cable (red boot) is
securely tightened to the positive (+) battery post.
Make sure boot is over battery post.
3. Carefully remove the protective wrapping around
the lug of the negative (-) battery cable (black boot).
4. Locate negative (-) cable attached to alternator
cable, remove tie and route to the negative (-)
battery post.
5. Pull back the black boot and securely attach
the negative (-) battery cable (black boot) to the
negative (-) battery post as shown in Figure 2.
Replace the black boot so it protects the cable lug
and battery post.
Positive
(Red)
Figure 2: Installing Battery Leads
NOTE: The electric start generator is equipped
with a battery charging feature. Once the engine is
running, a small charge is supplied to the battery
via the battery cables and will slowly recharge the
battery.
Negative
(Black)