Makita TL064D Instruction Manual page 7

Switch action
1. Switch lever
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch lever actuates properly and returns to the
"OFF" position when released.
is increased by increasing pressure on the switch lever.
Release the switch lever to stop.
Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
1
1. Switch lever 2. Lamp
keeps on lighting while the switch lever is being pulled.
onds after the switch lever is released.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
1
2
Reversing switch action
B
1. Reversing switch lever
CAUTION:
rotation before operation.
CAUTION:
the tool comes to a complete stop. Changing the direc-
tion of rotation before the tool stops may damage the tool.
CAUTION:
always set the reversing switch lever to the neu-
tral position.
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch lever cannot be pulled.
ASSEMBLY
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit
For tool with sleeve to retain the bit
Use only driver bit/socket bit that has inserting portion shown
-
(1) 12 mm (2) 9 mm
7 ENGLISH
1
Always check the direction of
Use the reversing switch only after
When not operating the tool,
Always be sure that the tool is
(1)
A
(2)