Installation; Restoring To Factory Settings - Chuango IP116 Plus Instruction Manual

5. Installation

Important: This camera should be placed where the WiFi signal is strong for optimal
performance.

6. Restoring to Factory Settings

Please read the steps below carefully before restoring to factory settings.
Note: If you don't want to clear the recordings stored on your memory card, you
can take out the memory card before restoring to factory setting.
Use a pin or paper clip to press the Reset Button (refer to page 5) for 10 seconds,
during the time, you will hear a beep in the first 3 seconds, continue to hold it until
two beeps are heard. After that, the camera will be restored to factory setting.
Restoring to factory setting will clear the connection between your camera and
your smartphone, therefore you should add the camera to your App again.
22