Precor C934 Owner's Manual page 34

C O M M E R C
QUICKSTART: This key lets the user bypass the Setup prompts and start work-
ing out immediately using the Manual course. Default values apply.
QUICKSTART Default Values
Prompts
COURSE
TIME
WEIGHT
AGE
The QUICKSTART key can be pressed any time during the Setup prompts.
For more information, refer to page 30, The Setup Mode and the QuickStart
Feature .
ENTER: Workout specific prompts which appear on the display need to be addressed
and then "entered" into the unit's memory by pressing the ENTER key. Refer to
Quick Steps to Working Out on page 37.
SPEED ▼▲: During a workout, the SPEED keys let the user decrease or increase
the running belt's speed. The display can show a range from 0.5 to 11 miles per
hour (1 to 18 kilometers per hour) and changes can be made in 0.1 increments
from 1 to 11 mph (1 to 18 kph). The display indicates a speed of "0" when a user
presses the SPEED ▼ key to stop the running belt.
Any time during a workout, the user can view the actual speed by lightly tapping
either SPEED ▼ or ▲ key. His or her "pace" (minutes per mile or kilometer)
appears in the left-most portion of the display. To change the speed, a user can
hold the key down for more than two seconds.
During Setup mode, the SPEED ▼▲ keys are used for data selection. Pressing
either ▼ or ▲ key changes what appears on the display, but does not affect the
speed of the running belt. Refer to Setup Mode and Prompts on page 29.
page 34
I A L P R O D
Default Value
Manual
Club dependent (usually 30 minutes - see page 25.)
150 lbs. (68 kg.)
0 : A valid AGE must be entered to utilize the SmartRate
display. If QUICKSTART is pressed after an AGE is entered,
then the SmartRate display will appear when a user wears the
POLAR ® chest strap. If no AGE entry occurs, then SmartRate
LED's light, but are not activated. Note that the POLAR
strap is available through a Precor dealer. Refer to Obtaining
Service on page 7.
U C T S D I V I S I O N
®
®
chest