Using Csafe Standard Equipment - Precor C936i Owner's Manual

C O M M E R C

USING CSAFE STANDARD EQUIPMENT

The C936i is fully compatible with CSAFE protocols. If the unit is connected to a
CSAFE master device, the user will be prompted to enter a user ID. Five zeros
appear on the display. The left zero blinks to indicate that it is awaiting input. The
following table provides information about the keypad functions:
User ID Entry:
INCLINE ▼ or ▲
SPEED ▲ or ▼
ENTER
RESET
A message indicates when the user ID is accepted by the CSAFE master
device. Then, the program prompt is displayed. See Quick Steps to Working Out
on page 37.
To review information about CSAFE specifications, visit the web site at:
www.fitlinxx.com/csafe
Additional CSAFE commands supported by the C936i software include:
SetProgram, SerUserInformation, GetUserInformation, GetOdometer, and
GetErrorCode
I A L P R O D
Program Keys
moves the blinking LED from field to field.
changes the number value in the selected field.
submits the displayed user ID. Note that if the 5 zeros are
being displayed when the user presses ENTER, user ID.
entry is bypassed and the program prompt appears.
resets the display to the Precor banner.
U C T S D I V I S I O N
page 27